GT6 Bulkhead reconstruction part 2

With the recent cold weather we have been having I've not been so keen to work on the car recently, but I had agreed to move the body over to a bodyshop this week, so I wanted to get the bulkhead finished off if possible.
I don't have and in progress pictures this time, but once again  the floorpan has been remodelled and the new bulkhead section welded in place, though this time the piece was fabricated.

Back inside the car, one of the radius arm strengthening brackets has been moved across, this is because the body was swing spring and will be going to Jones/Bowler CV.

I've made a start on the other side, unfortunately this bracket has had plates welded over it, but I found a decent one on my other spare GT6 body.

The body is now over at the bodyshop to have the rear light panel, rear wing and outer arch fitted, which they reckon they may have done by the end of the week, then it's back to me to finish the bracket on the heel board, repair both toe boards where it bolts down through to the chassis, patch a couple of holes on the back of the screen frame, put a new lip on the leading edge of the roof and if there is time, seem seal and paint the inside, all ready from paint in February, at least that's the idea